Ref. 26027- Used DMT BOPP MACHINE, year 2002
- Manufacturer: DMT
- Year: 2002
- Number of layers: 3
- Material: BOPP Output: 2800 kg/h
- Width (mm): 6800
- Extruder 1 Description: Manufacturer: Davis Standard, co-extruders with max output 150 kg/hr and 200 kg/h DC drive – 02 Co extruder motors Stand by L/D 30:1 Included with double filters with surface area: 0.81m2/unit
- Extruder 2 Description: TWIN SCREW EXTRUDER, TM 133 MW, 2800 kg/h, Melt pump Manufacturer: Maag AC drive Main filter: L.666 Surface area: 6.36 m2
- Extruder 3 Description: Co extruders, Manufacturer: Davis Standard, 2 co-extruders with max output 150 kg/hr and 200 kg/h DC drive – 02 Co extruder motors Stand by L/D 30:1 Included with double filters with surface area: 0.81m2/unit
- MDO description: 14 pre-heating rolls – Electrical heaters; 4 stretching rolls – Circulating oil; 2 annealing rolls – Electrical heaters; 5 nip rolls; AC drive; Stretching ratio 1:1 – 1:6
- TDO description: Chain and chain track System; Heating system: circulating air via individual heating system / zone (Electrical heater, motors, fans, sensor, etc) Edge guide system at inlet ATTENTION CHAIN OF TDO WAS REMOVED
- Pull roll unit: Cromed Rolls chilled by water; Edge trim on-line recycling unit; 2 corona treatment stations (up and down – Double treated) AC drive Thickness Gauge X-ray: – Measurement range: 5 – 100 micron
- Rewinder description: Turret Automatic change Slitter: Slitter not available
- Additional Information: ATTENTION: PARTS OF MACHINE WERE REMOVED
- Max mechanical speed: 280 m/min Edge recycling system Pneumatic conveying system Cyclone to separate resin and conveying air Metal separator Mixing hopper Suction conveying for Co- Extruder Edge trim recycling Edge trim grinder Conveying fans Recycling System – Erema 500 kg/h RM 80T Utilities: – Compressor, Boiler, Silos, Mill Rolls, Mill Roll Stands (corona and nip), Nip rolls stands, Over Head Crane (10 TM).